Furniture woodworking is just a few steps. If you do not follow the rules, it may affect the effect of woodworking edge banding. The importance of woodworking edge sealing need not be said, and the specification of its processes must be strictly observed.



Woodworking edge sealing is a key step in the production of furniture. The perfect completion of each step is a desirable signal that can achieve a good edge sealing effect. Many small furniture factories do not pay much attention to edge sealing when they are edged. As long as the wood glue can meet certain edge sealing requirements, this is the attitude of most small workshops. Although the edge of woodworking is not complicated, only a few simple steps are taken, but the production operation pays more attention to the benefits, and it is wonderful to finish the woodworking edge banding again and again efficiently and with high quality. Therefore, furniture edge-sealing factories that focus on production efficiency and quality must have step-by-step production habits. Woodworking sheet edge sealing has its correct operating procedures. Each step in the edge-sealing operation has its own reasons. The extension can undoubtedly have great benefits for the edge sealing of the workpiece, and can also improve the production efficiency of the sealing edge.



The correct steps of edge sealing are summed up by many experienced woodworking experts who have a high reference value. If there is any difficulty in the actual edge sealing operation, the details of the operation can be selected in a targeted manner.



In the first step, the edge banding glue is selected according to the workpiece to be processed and its sealing requirements. The furniture edge banding glue that can match the requirements of the edge sealing operation and has strong performance can lay a good foundation for the high quality woodworking edge sealing effect.



In the second step, let the rubber wheel on the edge banding machine raise the temperature to 180 ° C. When the corresponding signal indicator lights up, the other start button can be pressed to ensure the pressure of the air compressor is at 0.66 Pascal. Above the value.



In the third step, in the melting stage of the edge sealing glue, it is preferred to control the temperature of the glue between one hundred and sixty degrees to two hundred degrees. The temperature of the rubber shaft of the edge banding machine should be between 180 and 220 degrees.



The fourth step is to install the substrate for the edge banding machine, including the edge band and the plate. Among them, the workpiece should be close to the guide rail baffle, so that the plate to be edged can advance the work in parallel and evenly.



In the fifth step, quality inspection is very important, so it is necessary to carry out quality inspection before sealing each piece of sheet.



In the sixth step, the bad edge sealing environment will affect the effect of woodworking edge sealing. As a receiving personnel, it should clean the dust or debris on the surface before stacking the plates, laying a good foundation for the color of the board after sealing. .



In the seventh step, after each edge-sealing operation or before the operation, it is necessary to clean the wood chips and glue residue on the edge banding machine. When you do not need to start the edge banding machine for a long time, you should cut off the power. In the period of the work of the edge banding machine, the temperature inside the rubber tank should be lowered, and it can be controlled at 120 to 150 degrees. The establishment of the edge-sealing step is not a stubbornness of a woodworking work. If it is to be said at a higher level, it is a standard. There is no step in the woodworking edge sealing. In order to maintain the quality of the sealing, the operator is obliged to stick to this side step forever.

   2019-7-27