In the minds of many people, it is always considered that the operation of such a mechanical device is very difficult. In fact, this idea is wrong. To some extent, the more automated the operation of the device is easier, many of them are fool-like. . As long as we know the application principle of the melter, it will be easy to operate.

The application principle of the hot melt glue sprayer is mainly to melt the solid hot melt glue into a liquid state by using high temperature and then, and the pressure device and the program control system transfer the glue which becomes liquid to the hot melt hose and the hot melt glue gun. It is automatically sprayed on the substrate, and after the substrate is bonded, the hot melt is cooled to complete the bonding. It is a mechanical equipment for dispensing, spraying, gluing, gluing, and squeegeeing of hot melt glue machine with heating control, pressurizing device and liquid conveying. Basically it can be said that it is a one-step device. For novices, you can get started quickly, regardless of operating experience.

The hot melt glue machine can be used to melt hot melt glue sticks, hot melt rubber pellets, hot melt adhesive blocks and other hot melt adhesive products. It is generally used to melt hot melt rubber pellets. Because the surface area of hot melt rubber pellets is the largest under the same weight, it is also the easiest to heat and melt. Because of its simple operation and high work efficiency, hot melt adhesives are widely used in the packaging industry (carton, carton, handbag, courier bag, pearl cotton, etc.).

The following Weiwang hot melt adhesive simply describes the installation and operation process of the hot melt adhesive machine.

1. First, before the equipment leaves the factory, the hot melt glue machine manufacturer has already set up the pressurization device of the equipment, so the manufacturer does not need to adjust without special requirements.

2. After opening the rated power supply of the machine, turn on the heater switch and adjust the parameter values of each heater (plastic barrel, tube, gun). The temperature is set according to the temperature of the glue. The temperature values of different glues may not be used. same.

3. The hot melt hose and hot melt glue gun should be connected to the main machine (the gun body needs to be connected to the air pressure and power signal).

4. After preheating for 30-40 minutes, check that the glue in the rubber bucket is melted. You can turn on the motor power switch, adjust the motor speed, and adjust to the required number of working revolutions to operate normally.

   2019-7-22